Flow Totalizer - General Corrosion Topics

NOTICE

Forums are temporarily disabled while we are working on a new login procedure.

When migrating the old forums over to our new forums we were unable to retain the identity of the authors, so the old posts will show up as "anonymous". All NEW posts will show up credited to their authors. So please participate and share knowledge just as you have in the past.

You must log in if you are an existing user or register if you are a new user in order to contribute to the discussions.

Discussion Forums - The Hendrix Group

4/22/2007 9:00 AM

Joined: 1/1/0001

Posts: 0

Flow Totalizer

We are going to installed one new truck loading facility In this loading arm we are going to installed one Micromotion meter ( 8" ) and one MOV ( 8"). The operation philoshopy is like this. [1] We Preset the 25000 Lts. of set point and push START. [2] The MOV ( 480volt motor ) open and flow of the materail start. [3] As soon as 25000 lts of material pass via MMM, the MOV should CLOSE. In short It is a close loop . As this facility is in off-side so we didnot have DCS ( controller ) to control this close loop. Could someone pease suggested some any Controller / Totalizer for this application ?

5/24/2007 9:00 AM

Joined: 1/1/0001

Posts: 0

RE: Flow Totalizer

>We are going to installed one new truck loading facility > >In this loading arm we are going to installed one >Micromotion meter ( 8" ) and one MOV ( 8"). >The operation philoshopy is like this. > >[1] We Preset the 25000 Lts. of set point and push START. >[2] The MOV ( 480volt motor ) open and flow of the materail >start. >[3] As soon as 25000 lts of material pass via MMM, the MOV >should CLOSE. > >In short It is a close loop . > >As this facility is in off-side so we didnot have DCS ( >controller ) to control this close loop. >Could someone pease suggested some any Controller / >Totalizer for this application ? I am installing a like system in Petrocel Temex PTA Plant to load Acetic Acid, and will install a YOKOGAWA MODEL US 1000-21 CONTROL, AND PART LL1200-E10 4 DISKETTES YOKOGAWA. I hope this information help us. M. Dionisio Tampico M%C3%A9xico

Page 1 of 1

News

NEW! Calculation of Ammonium Salt Deposition Temperatures

With a little delay, our Calculation of Ammonium Salt Deposition Temperatures...read more

Sulfidic corrosion calculators NOW AVAILABLE

Our sulfidic corrosion calculators are now available at hghouston.com/calcula...read more

Stay Current

Sign up for our quarterly newsletter

covering updates on corrosion